![ardo a 500 user manual ardo a 500 user manual](https://i2.wp.com/usluga-spb.ru/remont/images/ardo9.jpg)
Condenser Design Calculation Pdf Download on this page. View and Download Ardo CARUM instructions for use manual online. ➘ If the washing machine drains directly into the waste water system, the free end of the machine drain hose must be inserted into a pipe of diameter not less than 40 mm. ➘ The water drain pipe outlet must be located at a height between 60 cm and 90 cm [fig. ➘ During washing, the water feed valve must be fully open. ➘ Insert the washer in the other end of the feed hose and screw it onto the washing machine [fig. ➘ Insert the washer with the filter (supplied with the washing machine) between the valve and the feed hose, then tighten the connection by hand [fig. ➘ The water feed pipe must be connected to the cold water system through a 3/4” screwed connection. This will clean the pipes of any dirt such as sand or rust (this operation is above all necessary when connecting the washing machine to a new connection or one that has been inactive for a long period of time). Connecting to the water supply ➘ The mains water pressure must be between 0.05 - 1.00 MPa (0.5 - 10 bar.) ➘ Before making the connection, open the tap or valve to allow a certain amount of water to flow. It is advisable not to install the machine in a room where the temperature may fall to below 0 o C. If the machine is installed on a carpeted floor, make sure that air is free to circulate between the machine and the floor. If the machine is not levelled properly, it will become unstable and noisy during operation and may cause damage. Make sure that the lock-nuts on the adjustable feet are properly tightened. Care must be taken when selecting the installation position and when levelling the machine. 60 CM MAX.90 CM Installing and levelling the machine After having chosen the most suitable position, level the washing machine using the adjustable feet [Fig.